Isuzu sewage suction truck

Isuzu sewage suction truck is a type of sanitation vehicle that is also widely used in environmental construction. Isuzu sewage suction truck are mainly used for sewage treatment in urban residential sewers and sewage treatment in some factories and enterprises. As a special-purpose vehicle, Isuzu vacuum cleaner truck will inevitably experience some failures during long-term use, affecting work efficiency. Therefore, it is best for us to master some emergency measures for Isuzu sewage suction truck failure to help solve urgent problems.

A common failure condition is a leaking fuel tank. If there is oil leakage in the fuel tank of the Isuzu sewage suction truck, it must be dealt with in time to avoid other dangerous accidents. At this time, we can wipe the oil leakage clean first, and then apply soap or bubble gum to the oil leakage area to temporarily plug the leak. If there is Isuzu epoxy resin adhesive equipped with the Isuzu vacuum cleaner truck, a better way is to use it directly to repair the holes, the effect will be better.

A ruptured fuel line is another common failure. If the oil pipe of the Isuzu vacuum cleaner truck is found to be ruptured, we can first wipe the rupture clean, then wrap it with soap or tape, and use iron wire to tie the entire rupture of the oil pipe, and then apply a layer of soap to ensure a seal.

When the oil pipe breaks, we can prepare a rubber or plastic pipe with the same diameter as the oil pipe as a socket. If the socket is not tight enough, iron wire can be used to further tighten it to prevent oil leakage.

If there are blisters in the cylinder head of the Isuzu vacuum cleaner truck, which may lead to oil or water leakage, we can select the electrician's fuse of the corresponding specifications according to the size of the blisters and gently tap into the blisters to eliminate the oil or water leakage problem.

When using an Isuzu vacuum cleaner truck, if you find oil leakage at the oil pipe joint, most of the cases are caused by poor sealing between the oil pipe bell mouth and the oil pipe nut. At this time, we can wrap cotton yarn around the bottom of the horn and tighten the oil pipe nut and joint. In addition to this method, we can also chew gum or maltose into a paste and smear it on the oil pipe nut seat, which can provide a good sealing effect after drying and condensation.

In addition, if the water inlet and outlet hose of the Isuzu vacuum cleaner truck breaks, we can simply use cloth strips to bandage small cracks. If the crack is large, it is best to put a bamboo pipe or iron pipe over the crack and tie it tightly with iron wire to prevent water leakage.

When we find that the fan belt of an Isuzu vacuum cleaner truck is broken, we can use iron wire to wrap the broken belt, or move the vehicle by starting and stopping.

In addition, if the screw hole slide of the Isuzu vacuum cleaner truck causes oil leakage or the connecting rod becomes loose and cannot work normally, we can use a hammer to flatten the original screw to expand both sides, and then tighten it. It should be noted that this method cannot be used multiple times and should be repaired as soon as possible.

It is very important to master the emergency measures for Isuzu vacuum cleaner truck failure to maintain its normal operation. Although Isuzu vacuum cleaner truck will inevitably encounter some failures during use, as long as we can flexibly use these emergency response methods, we can solve the problem at critical moments and ensure the improvement of work efficiency.